So, I went downstairs where my Hydroponics set up is to check on my parsley. its been about a week since I checked cause I was kinda busy, and too be perfectly honest, I forgot. I can see that they have start to sprout and then realized that I totally forgot that I was attempting to grow cuttings from my Curry plant. Sadly, the cuttings in the hydroponics are not looking good ( dried up) except the one all the way to the right. That one shows possibility of taking. Then I remembered that I also tried some cuttings using the method in one of the above videos, by cutting branch segments and basically submerging them in moist soil and stared some from the few seeds I had from the mother plant. These were in the boiler room, which is right next to the hydroponics, but with a closed off door so I totally forgot about them ( haven't checked since 10/20/21). After putting them in the moist soil, I put a clear plastic bag over them too retain the moisture and humidity. With the seeds, I covered it with a clear plastic tray for the same reason. This room stays at about a constant 80 F, so I figured things would dry up quickly ( and I'd likely forget, which I did).
I peeked under the plastic bag, and to my surprise, the branch cuttings are at a %100 success rate ( I still have time to kill them, but this was literally with no effort at all. I hope they take completely, so I can prune it correctly this time around and keep it bushy, not leggy, was its the leaves that are used primarily. I wish I knew and tried this years ago. The best way to compere this would be the same way I do figs ( which also take very easily). Anyway, hopefully these will mature to good sized plants.
only one of the seeds took so far. Im actually surprised , as this dried out almost completely ( the one with the small branches was still moist).